I've got a large order of 66 personalized bracelets. How can I make all those bracelets without being overwhelmed and losing my mind?? One bracelet at a time. Being constant is the trick for me.
The first step was to take my template and mark the sizes on my metal and then "cut each one by hand with metal sheers." I know!! Who does that?
The strips in the pile you see in the 1st photograph, have all been cut and roughly sanded into shape (I use an electric power tool for that job). Because I'm using a power tool, the strips get hot! hot! hot! I cannot hold them without a thick cloth to protect my fingers.
Also, you'll notice I drilled the holes in the metal strips. I love drilling the holes! Because I dip the tip of my bit into beeswax, there is a lovely honey scent in my studio! Oh! And check out the wood piece in the top photograph (the bottom left corner). See the holes? Those are the holes I leave behind after my drill bit goes through the metal and into the wood. Better to do that than ruin my table surface!
My next step is brushing my metal for a nice finish!
I'll keep you posted of my progress!
Thanks for dropping by. If you enjoyed my post, please share.
No comments:
Post a Comment